Free International Shipping With All Orders
20% OFF Orders Above $35. Use Code: 35CKOUT

How to Tie A Eldredge Knot

How to Tie A Eldredge Knot
October 29, 2017 Ties.sg
Eldredge knot is a complex knot and is produced by using the smaller end as the active end. This knot is larger than the Windsor Knot and create a braid-like effect.
  1.  Start with the wide end of the tie on the left and the small end on the right. The tip of the wide end should rest at the top of your belt buckle. Only move the active (small) end.
  2. Small end over the wide end to the left.
  3. Under the wide end and to the right.
  4. Up to the center, towards neck loop.
  5. Through the neck loop and to the left.
  6. Across the front, to the right. Then up into the neck loop from underneath.
  7. Down to the left and around the back of the wide end to the right. Keep this part loose.
  8. Bring it across the front towards the left and through the loop made in the previous step.
  9. Pull the small end towards the left to tighten.
  10. Up to the center, towards neck loop. Down through the neck loop and to the left.
  11. Up to the center, towards neck loop. Down through the neck loop and to the right. Keep this part loose.
  12. Across the front towards the left and through the loop made in the previous step.
  13. Pull the small end towards the left to tighten.
  14. Tuck the rest of the small end behind neck loop on the left side.
Download

Review

Knot Size 80
Symmetry 40
Difficulty 100
Overall 73%

Comments (0)

Leave a reply

Your email address will not be published. Required fields are marked *

*